lc1 ALWAYS rich
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Feb 2006
Location: Detroit
Posts: 1,234
Total Cats: 0
lc1 ALWAYS rich
I just installed my LC-1 wideband. I am running an Autometer Z-series NB gauge. I am using analog output #1 (Yellow wire) and have it set to the following...
1.002 volt at AFR 8.00
0.010 volt at AFR 17.98
Those are set using the "use air-fuel" option.
When I start the car it just pegs the furthest green LED. Give it gas, same thing. Just turn on the ignition, same thing. I suppose it could be my actual air/fuel but if I remember when I put the NB gauge on the NB sensor it was in the yellow with just ignition. I'm not sure what to do, can anyone help me? Thanks.
1.002 volt at AFR 8.00
0.010 volt at AFR 17.98
Those are set using the "use air-fuel" option.
When I start the car it just pegs the furthest green LED. Give it gas, same thing. Just turn on the ignition, same thing. I suppose it could be my actual air/fuel but if I remember when I put the NB gauge on the NB sensor it was in the yellow with just ignition. I'm not sure what to do, can anyone help me? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM