Identification of item Please
#1
Senior Member
Thread Starter
Join Date: Oct 2004
Location: SWAMPS OF FLORIDA !!!
Posts: 1,161
Total Cats: 0
Identification of item Please
Anyone know what the **** this thing is?
It connects to the transmission housing tail. The other end connects to the speedometer cable. The writing says, " 8 pulses per revolution"
So far I've gotten possible sensor for cruise control which I removed quite awhile ago. Of course the car is a 92 manual trans.
Anyone seen one and knows what it is?
It connects to the transmission housing tail. The other end connects to the speedometer cable. The writing says, " 8 pulses per revolution"
So far I've gotten possible sensor for cruise control which I removed quite awhile ago. Of course the car is a 92 manual trans.
Anyone seen one and knows what it is?
#6
It's a speedometer sender, as would be used with an aftermarket speedo gauge. I've installed a lot of those before. So technically, if your MS has speed input, you should be able to make this communicate with it.
I was about to say it may be an early AutoMeter sender, but as far as I know, they've always used 16 pulse-per-rev. senders.
I was about to say it may be an early AutoMeter sender, but as far as I know, they've always used 16 pulse-per-rev. senders.
#12
I found this info whilst getting a Mercedes COMAND satnav/media centre to work in my MX-5 a la Frank Devocht.
#13
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
PS--there's plenty of ways of getting speed signal to a NAV system (or trac control), including VSS at the back of the cluster. I'm just too tired/lazy/apathetic to detail now.
#14
I sold my unit after someone offered me silly money for it and the CANBUS emulator that I used to make it work in my VERY NON CAN miata. I never took any pics of my install but here are some pics that Frank took of his.
If anyone wants to do this I will provide a full writeup/howto including part numbers and how to make CAN work in exchange for some old T25 water hardlines.
If anyone wants to do this I will provide a full writeup/howto including part numbers and how to make CAN work in exchange for some old T25 water hardlines.
#16
That one isn't mine. It belongs to a fellow called Frank Devocht. I may do the write-up anyway on the understanding that someone in the future may have some hardlines and send them my way rather than bin them.
Edit: https://www.miataturbo.net/forum/showthread.php?t=23447 [/threadjack]
Edit: https://www.miataturbo.net/forum/showthread.php?t=23447 [/threadjack]
Last edited by Duckie_uk; 07-11-2008 at 02:38 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
Rudes333
Miata parts for sale/trade
17
11-05-2015 01:16 PM