Bye, Bye, MAF
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: Athens, GA
Posts: 247
Total Cats: 0
Bye, Bye, MAF
Finally removed the mass air flow sensor (thanks to the megasquirt). Here is my Lowe's special intake, a temporary set up until I go turbo. I've laid the radiator back in hopes of running my intercooler pipes over the radiator. The cover panel was my first attempt, I cut it out of some scrap fiberglass RV siding that I picked up at my parent's store. I'll make a cleaner one once the turbo is in.
Mmmm... PVC and brass plumbing fittings
The GM air temp sensor
The filter as seen through the front grill
The car runs, but it is running rich. I'll be working on that issue this week...
Mmmm... PVC and brass plumbing fittings
The GM air temp sensor
The filter as seen through the front grill
The car runs, but it is running rich. I'll be working on that issue this week...
#2
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
anyone think the IAT sensor sitting right near the radiator is gonna get heat soaked and throw off the the air temps? I was a lil concerned about mine and it's much further away and off to the passenger side of the tb
Thread
Thread Starter
Forum
Replies
Last Post