LC-1 Install questions

Reply Subscribe

Thread Tools

Search this Thread

12-08-2009, 07:50 PM

dpexp

Junior Member

Thread Starter

iTrader: (6)

Join Date: Dec 2007

Location: PBC.

Posts: 400

Total Cats: 0

LC-1 Install questions

Has anybody used the stock O2 sensor location, with the stock ECU, utilizing the LC-1 analog 1 output? and if so did you have to reprogram the analog 1 output?

12-08-2009, 08:31 PM

SKMetalworks

Elite Member

iTrader: (7)

Join Date: Jan 2007

Location: Renton Washington

Posts: 1,731

Total Cats: 4

Someone correct me if I'm wrong but i don't think the stock ecu will read the wide band. I believe most people just use a second bung and leave the stock one in.

12-08-2009, 08:43 PM

dpexp

Junior Member

Thread Starter

iTrader: (6)

Join Date: Dec 2007

Location: PBC.

Posts: 400

Total Cats: 0

The LC-1 has a narrowband output (analog 1). analog 2 is the wideband output. Hence the original question.

12-08-2009, 08:54 PM

shuiend

mkturbo.com

iTrader: (24)

Join Date: May 2006

Location: Charleston SC

Posts: 15,176

Total Cats: 1,680

I have been running an LC-1 and MS-Parrallel for about 2.5 years. When I first installed my LC-1 it went in the stock o2 bung and I wired the narrow band output to the stock ecu and it has never given me problem. Still wired up that way now.

12-09-2009, 08:28 PM

micagreenmachine

Junior Member

Join Date: Jul 2007

Location: Mundelein, IL

Posts: 59

Total Cats: 0

Wired mine like that 2 weeks ago. Still running on the stock ecu... Runs fine. I tweaked the settings on analog one a little bit to stabilize the AFR, it was swinging quite a bit when I first put it in there. 2 8 Ohm resistors wired in series to fake out the O2 heater circuit. No CEL, no pending codes.