Re-sizing and printing Hydra maps
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: May 2007
Location: Austin, TX
Posts: 1,881
Total Cats: 2
Re-sizing and printing Hydra maps
Is there anything in the software to allow me to resize my maps to fit it all on one screen for viewing and printing?
And once I get it to all fit on a single screen is the only way to print it by using a screen capture?
This may seem dumb, but how do I add cells to the map for increased boost and additional rpms? I'm sure this is simple and I just am overlooking it.
And once I get it to all fit on a single screen is the only way to print it by using a screen capture?
This may seem dumb, but how do I add cells to the map for increased boost and additional rpms? I'm sure this is simple and I just am overlooking it.
#2
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
pretty sure there's no way to get them out of the software for viewing/printing. at least not in the pre-2.6 versions. screen cap and stitch seems like the way to go.
you can't add cells, but you can change their spacing. pre-2.6 it's under the settings menu for "grid x" and "grid y".
you can't add cells, but you can change their spacing. pre-2.6 it's under the settings menu for "grid x" and "grid y".
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM