Journalist faked toyota acceleration vid
#3
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,019
Total Cats: 6,587
So, because the original footage of the tach-in-motion was unusable, an editor made an artistic decision to splice in a different piece of footage.
And this affected the validity of the story in what way?
The actual news is that the test scenario which David Gilbert created is essentially an unrealistic fault condition- inserting a 200 ohm resistor between a pair of wires on the pedal sensor. In the real world, wires may very well short together (~ 0 ohms) or be cut / broken (~ ∞ ohms), or even immersed in a corrosove / conductive liquid (several kiloohms), and the ECU's fault-detection characteristics would have identified any of these failure modes and trapped them. But I can think of no plausible failure mode which would result in a 200 ohm bridge between two wires due to mechanical abrasion / assembly damage / whatever.
Essentially, Mr. Gilbert essentially went in and figured out precisely the correct conditions to inject a signal that was within normal operating parameters. Hell, I could do that with practically any system on any car if I had enough time on my hands. From an engineering perspective, this would be like removing the spring which closes the throttle plate (which would result in full acceleration) and then claiming that failure of the spring which closes the throttle body can result in uncommanded acceleration, and that the use of springs to manage the throttle plate is dangerous.
This isn't bad journalism- it's bad science.
Detailed analysis of the test:
http://www.autoblog.com/2010/03/08/t...-demonstratio/
And this affected the validity of the story in what way?
The actual news is that the test scenario which David Gilbert created is essentially an unrealistic fault condition- inserting a 200 ohm resistor between a pair of wires on the pedal sensor. In the real world, wires may very well short together (~ 0 ohms) or be cut / broken (~ ∞ ohms), or even immersed in a corrosove / conductive liquid (several kiloohms), and the ECU's fault-detection characteristics would have identified any of these failure modes and trapped them. But I can think of no plausible failure mode which would result in a 200 ohm bridge between two wires due to mechanical abrasion / assembly damage / whatever.
Essentially, Mr. Gilbert essentially went in and figured out precisely the correct conditions to inject a signal that was within normal operating parameters. Hell, I could do that with practically any system on any car if I had enough time on my hands. From an engineering perspective, this would be like removing the spring which closes the throttle plate (which would result in full acceleration) and then claiming that failure of the spring which closes the throttle body can result in uncommanded acceleration, and that the use of springs to manage the throttle plate is dangerous.
This isn't bad journalism- it's bad science.
Detailed analysis of the test:
http://www.autoblog.com/2010/03/08/t...-demonstratio/
#5
Elite Member
iTrader: (1)
Join Date: May 2009
Location: Jacksonville, FL
Posts: 5,155
Total Cats: 406
It doesnt matter, theyre journalist, that means no opinions, no show, all truth. If they didnt like they shot they got then though ****, you dont fake a shot of the car ripping to redline like a sport bike.
That was blantantly trying to make it scarier than it is. Everybody know that *** mobile is slow as ****. A real shot of the tach would show the needle creeping towards redline like hustlers homeosexual urges creep on him after a few beers, theres nothing scary about that.
That was blantantly trying to make it scarier than it is. Everybody know that *** mobile is slow as ****. A real shot of the tach would show the needle creeping towards redline like hustlers homeosexual urges creep on him after a few beers, theres nothing scary about that.
#11
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,490
Total Cats: 4,079
Thread
Thread Starter
Forum
Replies
Last Post