Braineack

iTrader: (62)

it wasnt just my sensor that crapped out, the LC-1 is not working properly....

no sensor plugged in and get "voltage too low error 9"

plugged matt's sensor in and get "heater circuit open error 2"

same thing on my sensor....

retraced the wiring, nothing has changed, just crapped out on me.

So, tomorrow is the dyno and now I gotta rely on the crap "sniffer" for a wbo2 plot....oh well, it's tuned close where i dont need one, but I was in the middle of fine tuning cruise when it died, I'll propably have crap for fuel mileage on the way....

that DIY WB guy is looking a lot better to me right now.

Ben

iTrader: (33)

That really sucks man. Call Innovate and speak with Phillipe. Maybe he'll offer a RMA on it and bench test it.

y8s

iTrader: (8)

isn't someone bringing a brand new LC1 setup? plug and play baby

TurboTim

iTrader: (9)

Damn. If you had known earlier, I could have picked up my LC1 box at the store this morning when I picked up my helmets. Sorry :(

Al Hounos

What does DIY autotune think about putting a resistor on the LC1 analog out like the innovate guys say to? How has it been dealt with on the PnP?

Braineack

iTrader: (62)

go back :(

Splitime

iTrader: (24)

Call Innovate at least, they warrantied my LM1 awhile back and I was the second owner. Very easy people to deal with.

Braineack

iTrader: (62)

Yeah, actually PMed Jerry from DIY since I bought it through them...ill play with it later and try again, but then I'll get in touch with Philippe at Innovative.

I might rip it out completely and try to temporarily rewire it, as I routed it all donkey. But it was wokring and then not, and another sensor throws the same errors, so i dont have my hopes set too high.

samnavy

iTrader: (7)

I'll be bringing my brand new, still in plastic LC-1 to NEDD... you're welcome to give it a shot!

Braineack

iTrader: (62)

I could at least try to wire it up and see if i get the same error, but i doubt I'll get around to it tomorrow during the course of the day...its only a few wires, but i really dont know if wanna bother crawling under the car and pulling ****..we'll see....

ill be fine on the dyno without one, just sucks that i wont be able to capture my logs with the wbo2 reading...and i really cant tune anything, so im stuck with my map as is....but i do need a fix sometime soon...if its not one thing it's always another.

that7guy

iTrader: (1)

Dude that sucks!