Hobart Handler 120
#4
Slowest Progress Ever
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
I have a Hobart (too lazy to go in the garage and check the model) but it runs on 110V. It is NOT gasless, because flux core is junk core. It is the best welder I have ever used for welding exhaust tubing and body panels.
#7
Elite Member
iTrader: (5)
Join Date: Oct 2011
Location: Detroit (the part with no rules or laws)
Posts: 5,677
Total Cats: 800
I don't even suggest a flux core to a beginner, or someone looking to melt some stuff together once a year.
But perhaps i'm biased.
I have the Miller version of the one you posted at home. That one is dumbed down, but simple parts are basically the same, the drive wheels for example.
But perhaps i'm biased.
I have the Miller version of the one you posted at home. That one is dumbed down, but simple parts are basically the same, the drive wheels for example.
#12
It'll be fine if you get the pieces to use shielding gas... for $75 it's hard to go wrong on any name brand welder. I've had my Lincoln SP100 since 1987, finally had to fix something on it the past spring (gas solenoid gummed up, took about 15 minutes to fix). I can still get parts for it. More than large enough for automotive use, unless you need to weld side bars on D-derby cars.
#13
Hobart 500500 Handler 140 115-Volt 25-to-140 Amp Gas/Metal/Arc Single-Phase Wire Welding Package - Amazon.com
I bought the Handler 140 as my hobby welder. After learning stick and MIG on high end industrial equipment, and it was horribly disappointing to see the aftermath of a flux core weld using the Handler 140. So far the only major project I've used it on was to rebuild rocker panels using the flux core wire. As others have said, you will want the gas unless you plan on wasting a LOT of time on cleaning up after yourself.
#14
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,176
Total Cats: 1,680
When I was looking for a cheap mig welder I had decided to go with the Northern Industrial Welders MIG 140I Wire-Feed MIG Welder. I liked that the welder had continuous voltage adjustment, instead of just 4 choices that most other cheap mig welders use.
#15
Slowest Progress Ever
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
There's a small welder at work that is amazing. I think it's a miller (140?) auto set. You can manually set it, or just turn the **** to the metal's thickness and it'll weld perfect. Hands down the best little mig welder I have ever used.
Thread
Thread Starter
Forum
Replies
Last Post
kronikker
Miata parts for sale/trade
17
10-06-2015 10:18 PM