mechanical aptitude test
#1
Supporting Vendor
Thread Starter
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
mechanical aptitude test
shouldn't take more than 10 minutes or so.
http://www.forddoctorsdts.com/quizz...calAptitude.php
80% 'passes' and 85% is average.
I got a 96%, missed 6 & 11, and I'm blaming that on their shitty drawings (no measurements given in 6 and unclear in 11)
.
http://www.forddoctorsdts.com/quizz...calAptitude.php
80% 'passes' and 85% is average.
I got a 96%, missed 6 & 11, and I'm blaming that on their shitty drawings (no measurements given in 6 and unclear in 11)
.
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,490
Total Cats: 4,079
i suck i got a 50%, i would have gotten 100% if it weren't for the gear/pulley questions. I missed almost all of the for unknown reason. I also rushed. I got everything from that section on correct :(
#7
Supporting Vendor
Thread Starter
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
If you got everything else right, I'd say you have more than enough aptitude than it takes to splice a handful of wires. You'll be fine.
#15
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
90%, but they aren't too clear.
the fans will rotate in same or opposite? well do they mean same sitting side by side or same facing each other?
oops on question 44, I thought it was air in the pipe, not water.
the fans will rotate in same or opposite? well do they mean same sitting side by side or same facing each other?
oops on question 44, I thought it was air in the pipe, not water.