conrader

Hi,

I've just finished plugging Ms2/extra to my '96 NA miata with 1.8 swapped from another (sensors still from 90hp 1.6 miata). I was able to start it yesterday but it runs bad. I smell gas after 30 secs of running and idle is not smooth at all. Can someone provide me with a base MSQ file I could use to fine tune?

My miata does not work on 4g63 settings, however it runs pretty fine on CAS 4/1. Is that wrong?

KS

MX5RACER

Not sure if you can use mine or not as I am running a DIYPNP (Microsquirt) in my '90 with a '96 motor.

https://www.miataturbo.net/megasquirt-18/90-w-96-engine-diypnp-tuning-help-please-47305/

Braineack

iTrader: (62)

if it doesn't run on 4G63, you're doing it wrong.

conrader

Are you sure? It shows RPM perfectly on CAS 4/1. Actually mods are exactly the same for both. Remember, I have a sensor from 90hp '96 1.6 Euro version.

conrader

Wow thx! I used your msq and idles very smooth. I have not even adjusted timing.

MX5RACER

No problem, I am glad that it worked for you. I still need to work on some of the settings as my car idles at 1400, and I am not sure if it is a vacuum leak or something else.

Braineack

iTrader: (62)

Take a look at your PWM closed Loop Idle Targets. and if they look good, increase your Integral Gain % until you can reach said target.

conrader

I've noticed the same. As the car warms up it idles higher than when its cold so its definatelly not a leak. Mine idles at 1400 when its warmed up.

Braineack

iTrader: (62)

then you probably need to reverse the polarity on your idle valve settings.

conrader

OK. I will let you know if it helped. What about CAS? For some reason it works perfectly well (well maybe some jumps from time to time) on 4/1 and I get no tach reading on 4g63. The wiring is exactly the same for both so I dont believe its a MS hardware problem.

Testing on jimstim 4g63 seems weird as to get RPM I need to unplug second trigger and plug it again - then it I'm getting RPM and I can adjust it by pots.

4/1 seems to work without any problem on jimstim.

MX5RACER

Sorry for the newbness of this question, but where might I do that? Hardware (swapping wires at the valve or inside Megasquirt) or software? I am using Tunerstudio btw. Thank you.

Braineack

iTrader: (62)

https://www.miataturbo.net/showpost....8&postcount=46

this might help.