car cranks, no tach signal on Megatune
#1
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
car cranks, no tach signal on Megatune
So I finally got everything straightened out and now my computer can read from the MS. I turn the key and it cranks and cranks, but I am getting no tach signal on Megatune. I'm sure it's getting fuel though, cause I turned the ignition off, and then I turned it on again, and it popped out the exhaust. Why would that happen if it didn't even crank over? My AFR on Megatune says like 4.80 which would mean super rich, but my G3 gauge in the LC-1 shows like 10.5? This is a MS-1 3.0 that was run in parallel on a 97, and now I retrofitted it to my 99. I loaded this...MSPNP_MM9697_Base_Map_012808.msq from http://www.megasquirtpnp.com/mspnp_downloads.htm.
My CAS came from Flyin Miata Salvage.
Any advice or suggestions are always helpful guys!
My CAS came from Flyin Miata Salvage.
Any advice or suggestions are always helpful guys!
#2
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
If my CKP and CMP wires are backwards, would I get no signal on Megatune? But would the injectors still fire? It's gotta be something so stupid and simple....
Thread
Thread Starter
Forum
Replies
Last Post
JacksonRacingEngines
Engine Performance
10
09-10-2015 09:52 AM
AlwaysBroken
Engine Performance
4
09-04-2015 01:35 PM