Clos561

iTrader: (3)

i chose the ini that i downloaded from the write up and no go.

i dont see the one its telling me to choose in my list of ecudef either


http://i90.photobucket.com/albums/k254/los561/ecu.jpg

http://i90.photobucket.com/albums/k254/los561/ecu2.jpg


am i supposed to connect anyway after selecting the downloaded .ini file that is in the ms2 extras?

Clos561

iTrader: (3)

Braineack

iTrader: (62)

you have an older firmware loaded.

you need this locally for your project: http://www.msextra.com/doc/ms2extra/...u_20100522.zip

Clos561

iTrader: (3)

why am i getting the same values for closed and full throttle adc? there is also a ticking that goes on and off every 3-5 seconds sounds like its oming from the steering column

-getting a conflict with tacho output too.

Braineack

iTrader: (62)

email me your msq. ticking would be fuel pump relay.

Clos561

iTrader: (3)

i dont know what msq is or how to email it. this is all very new to me

Clos561

iTrader: (3)

just figured it out, sent msq file.

Clos561

iTrader: (3)

changed my tach out option and still have config error. cannot get the closed and full adc count they are bothing showing up the same value as closed count after i hold gas down and try to get full adc

aaronc7

iTrader: (8)

just run the base map from diypnp for 99. i used that and car fired right up