ego control
08-25-2016, 01:03 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2011
Location: Oregon
Posts: 301
Total Cats: 4
ego control
I'd like to turn off the wideband. It wasn't obvious to me how this is done in tuner studio under EGO control. MS3. Paid version of TS.
Back story is that I am trying to street drive my track-day car thru the end of the summer. While it's been dyno tuned and runs well flat out, the car doesn't run well enough for street driving. Hard to start when warm, surging idle and stalls at stop lights, and a little lean on tip in. I'd like to try to play with this in TS. However, my wideband is fried. I'd like to get a few issues addressed before putting the car away for the season and 'just thought I could turn off the wideband.
Back story is that I am trying to street drive my track-day car thru the end of the summer. While it's been dyno tuned and runs well flat out, the car doesn't run well enough for street driving. Hard to start when warm, surging idle and stalls at stop lights, and a little lean on tip in. I'd like to try to play with this in TS. However, my wideband is fried. I'd like to get a few issues addressed before putting the car away for the season and 'just thought I could turn off the wideband.
Reply
0
0
08-25-2016, 01:06 PM
#2
Junior Member
Thread Starter
Join Date: Apr 2011
Location: Oregon
Posts: 301
Total Cats: 4
I found it under EGO type.
Another Q: I am using time based acceleration enrichment. Can I change the AE table to only effect the enrichment at tip-in, or will this change AE throughout the previously tuned range?
Another Q: I am using time based acceleration enrichment. Can I change the AE table to only effect the enrichment at tip-in, or will this change AE throughout the previously tuned range?
Last edited by gtred; 08-25-2016 at 01:16 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Al Hounos
MEGAsquirt
4
05-28-2006 10:57 AM
