Can't get A/C to work.
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Navarre, Fl
Posts: 280
Total Cats: 8
Can't get A/C to work.
I've built a diypnp for my 2000 miata. I've set up A/C exactly per diyautotune's instructions. Every time I look at the transistor for input 1 its blown. I've replaced it twice. Any idea where i should go from here?
#7
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,490
Total Cats: 4,079
if youre blowing transistors then you have something wired incorrectly.
it's a very simple circuit:
when you turn the a/c on it sends a ground to the input circuit, that in turn sends a ground back out to 1S and 1L--activating the a/c fan and a/c compressor relays.
I'd reach out to DIYAUTOTUNE for better advice.
it's a very simple circuit:
when you turn the a/c on it sends a ground to the input circuit, that in turn sends a ground back out to 1S and 1L--activating the a/c fan and a/c compressor relays.
I'd reach out to DIYAUTOTUNE for better advice.
#16
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Navarre, Fl
Posts: 280
Total Cats: 8
So I started the car with the a/c inputs and outputs now going through input 2 circuit. I cut out the 2.2k resistor. Turned the A/C on and nothing happened. Didn't hear the click of the a/c relay and the transistor for input 2 is just fine. I'll resolder the connections to make sure they are good, but to me they look good.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
russian
Miata parts for sale/trade
6
10-08-2015 03:01 PM
SuperSneakySecretSquirrel
Meet and Greet
5
09-06-2015 08:30 PM