Timing Question
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2014
Location: Silver Spring, MD
Posts: 659
Total Cats: -16
Timing Question
MegaSquirtPNP by DIYAutoTune.com
Got a little confusion about the install instructions here (above). My timing is mechanically set to 10 deg advance. When installing the MS and setting trigger angle in TS (in Ignition Options), do you enter 0 or 10 in the Trigger Angle/Offset box?
TIA!
Got a little confusion about the install instructions here (above). My timing is mechanically set to 10 deg advance. When installing the MS and setting trigger angle in TS (in Ignition Options), do you enter 0 or 10 in the Trigger Angle/Offset box?
TIA!
#3
Senior Member
iTrader: (1)
Join Date: Dec 2010
Location: Farmington Hills, MI
Posts: 1,218
Total Cats: 175
You just need to make sure that when you tell MS to command 10 degrees (using fixed advance) that your timing light shows 10 degrees advance. If it doesn't, then you use the trigger angle to compensate. So, your trigger angle isn't a predefined value, it's something you have to tune in.
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM