MS1v3 why leave q6,q8 out?
03-26-2007, 01:01 AM
#1
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jul 2006
Location: Central California
Posts: 2,543
Total Cats: 4
MS1v3 why leave q6,q8 out?
As quoted from Post 18 of Kags buildup:
Ecugrad: "Ok, now I am home and have my MS infront of me. I dont know why in the hell I didnt install Q16? I will."
Kags: "I think you need Q16 for ms2, I dont think it hurts having it, but dont think its absolutly needed for ms1 w/ msns."
Ecugrad: "Why do we leave Q6 and Q8 out?"
Kags: "They apperantly lower the voltage too much to fire the coil if you leave them in..."
.............
Um so, are we sure about this? I have seen absolutely nothing about this anywhere else (granted i havnt looked around the Msefi forums much)?
Ecugrad: "Ok, now I am home and have my MS infront of me. I dont know why in the hell I didnt install Q16? I will."
Kags: "I think you need Q16 for ms2, I dont think it hurts having it, but dont think its absolutly needed for ms1 w/ msns."
Ecugrad: "Why do we leave Q6 and Q8 out?"
Kags: "They apperantly lower the voltage too much to fire the coil if you leave them in..."
.............
Um so, are we sure about this? I have seen absolutely nothing about this anywhere else (granted i havnt looked around the Msefi forums much)?
Reply
0
0
03-26-2007, 12:17 PM
#2
Supporting Vendor
Join Date: Sep 2006
Posts: 2,332
Total Cats: 67
It's possible to make it work while leaving Q6 and 8 in. Our version of the installation directions leave them in, and we've been using it on our Miata test mule with no trouble. Many output circuits can be built several different ways.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Fab9 Tuning - Miata Performance Parts
0
09-11-2015 12:02 PM
itsMikey
Insert BS here
0
09-05-2015 02:56 PM
