I am confused as fuck
#1
I am confused as ****
I have been searching for hours, reading posts for hours, read megasquirt websites, etc...I find pieces of information here and there, but nothing that ties everything together. I don't understand this:
I am trying to tune my car (fuel I guess-VE-haven't done anything with timing just using the PNP map) Why do I bother putting numbers into the AFR target table in MT yet have 0 in Controller step that basically disables and doesn't reference the target tables while I'm driving? I have just been driving the car, then going into MLV and running the analyzer against the same AFR target table "afrbins1". Is this right? I have gathered that it's not good to be in boost and have the controller step enabled (not set to 0) but at what point do I change controller step to something other than zero? And what do I change it to?
I am trying to tune my car (fuel I guess-VE-haven't done anything with timing just using the PNP map) Why do I bother putting numbers into the AFR target table in MT yet have 0 in Controller step that basically disables and doesn't reference the target tables while I'm driving? I have just been driving the car, then going into MLV and running the analyzer against the same AFR target table "afrbins1". Is this right? I have gathered that it's not good to be in boost and have the controller step enabled (not set to 0) but at what point do I change controller step to something other than zero? And what do I change it to?
Thread
Thread Starter
Forum
Replies
Last Post
AlwaysBroken
Engine Performance
4
09-04-2015 01:35 PM