TPS mod on DIyPnP
#1
TPS mod on DIyPnP
right now there is a resistor between TPS and VR-
I understand I remove this resistor.
Then run a jumper to my TPS signal pin from the TPS solder point.
I also need a gnd jumper.
Then do I use the solder point marked vref near the "boot" section of the board. Or do I use the VR+ two holes to the right of TPS?
I understand I remove this resistor.
Then run a jumper to my TPS signal pin from the TPS solder point.
I also need a gnd jumper.
Then do I use the solder point marked vref near the "boot" section of the board. Or do I use the VR+ two holes to the right of TPS?
#2
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Dunno what your on about, vr+2 is for vr input conditioning, but to fit a variable TPS, remove said resistor, then wire gnd, tps sig and 5v vref to the corresponding pins on the tps.
Simples
Simples
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM