dwink

iTrader: (1)

Hey all. I have my car running pretty well on Brain's MS3.

One item that is stumping me- when I warm start the car- it goes right into CL idle and idles great. If I blip the throttle, it (obviously) comes out of CL, but it won't go back in.

Thoughts?

aidandj

iTrader: (5)

Post a log. There are like a hundred different reasons that could be happening.

gooflophaze

Post your msq. Post your CL idle settings. Post a log of idle and then lockout.

Otherwise - Uhm.. don't blip the throttle. Because you haven't given any information other than it doesn't work.

deezums

iTrader: (3)

I bet a nickel you are running outside closed loop idle entry parameters after that throttle blip.

You shouldn't try and use closed loop idle to calm down crazy idle speed issues, you should fix whatever is making the engine race. You will never get consistent and useful closed loop idle if you don't.

dwink

iTrader: (1)

Sorry- posted.

Side note- not trying to tune crazy idle speeds with closed loop. The car is idling well both open and closed loop. It just seems I should be going back into closed loop in real world settings.

deezums

iTrader: (3)

Looks fine, I'd check the closed loop idle entry parameters to see why it's not turning on, has to be something there.

dwink

iTrader: (1)

Here are settings. I am going to work on it today to see if I can get it going.

Braineack

iTrader: (62)

you have strong vacuum. tune the Max Decel Load(%). if it's still set at 29.5 then you'll never kick back into CL because your vacuum stays well under that value. That's tuned assuming you idle around 31-32-33-34% load at idle. CL wont kick back in until the load goes higher than 29.5 again.

dwink

iTrader: (1)

Thanks guys! Probably strong vacuum combined with high altitude...

Problem corrected, idle is very nice...