Bench testing EBC
11-25-2007, 11:56 AM
#1
Elite Member
Thread Starter
iTrader: (9)
Join Date: Jul 2007
Location: NYC
Posts: 5,710
Total Cats: 3
Bench testing EBC
I just added EBC to my MS but id like to make sure that the circuit works. I dug around in megatune but I just cant figure out how to make it engage at 110kpa so I can see if the middle leg and the gnded leg are opening and closing.
What menu should I be in and what values should I change?
What menu should I be in and what values should I change?
Last edited by Saml01; 11-25-2007 at 12:34 PM.
Reply
0
0
11-25-2007, 01:11 PM
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,490
Total Cats: 4,079
I dont think you'll be able to with the stimulator, since the mods kill the RPM signal, and you need at least 100rpm to activate it.
what i'd would do is hook the solenoid up, tune the DC map to be 100% throughout the entire map....the solenoid should close, when you get over 100rpm
what i'd would do is hook the solenoid up, tune the DC map to be 100% throughout the entire map....the solenoid should close, when you get over 100rpm
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
