10g questions
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2007
Location: santa cruz
Posts: 245
Total Cats: 1
10g questions
I just flashed hi-res and I have 2 questions:
Whenever I burn a new .msq, my fuel pump primes. It never did this before. Is this normal?
MAT reads 4 deg higher. Previously the CLT and MAT were spot on, now intake is off. Is this normal? Setup is standalone with no R7. Is 4 degrees worth correcting or should I just leave it?
thanks
Whenever I burn a new .msq, my fuel pump primes. It never did this before. Is this normal?
MAT reads 4 deg higher. Previously the CLT and MAT were spot on, now intake is off. Is this normal? Setup is standalone with no R7. Is 4 degrees worth correcting or should I just leave it?
thanks
#4
Junior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2007
Location: santa cruz
Posts: 245
Total Cats: 1
re: pump priming, mine always primed at ignition on but no other time.
re: resistance scale, I copied all my files into a new HR project, including the .inc files, so it must be something else...
thanks
re: resistance scale, I copied all my files into a new HR project, including the .inc files, so it must be something else...
thanks
#7
Junior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2007
Location: santa cruz
Posts: 245
Total Cats: 1
Yes, it primes each and every time I load an msq. Never did this before. Also, I hear a relay or two clicking behind the dash when I load an .msq. Not sure wtf. Also, my IAC is moody. Also, when I load an .msq, sometimes MT doesn't show the file name at the bottom like it used to. I have made zero hardware changes. Must be something else. Otherwise, hires is supertits.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM