ms3 'base' maps
#2
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
I've attached a map I built for the shop's 91 turbo car (1.6, BEGi S3, GT2560r, 460cc/min). The car ran pretty well on the dyno, but be advised that this was built on old firmware (it was new at the time), and I didn't take time to fine tune things like idle, start up and warm up routines, etc. But the fuel and ignition tables were pretty solid. I'd like to thoroughly set up an MS3 on a Miata, but there has not been time yet.
Posted for evaluation only. Use any part at your own risk.
Posted for evaluation only. Use any part at your own risk.
Thread
Thread Starter
Forum
Replies
Last Post