"Conflict with additional injectors PT2/4" on DIYPNP
07-10-2016, 02:59 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2012
Location: Israel
Posts: 650
Total Cats: -481
"Conflict with additional injectors PT2/4" on DIYPNP
Hey,
I ran fw 332 and all was good then I had to upgrade to 342 and this error came up, I just re-flashed and it went away...
Yesterday I wanted to start tuning my newly installed EBC and I got this error after sending the MSQ from the laptop to the ECU...
Things I tried:
- Power cycle
- fw downgrade to 341 (choosing fw for DIYPNP)
- disable IAC
- new project
- disabling seq inj - make the error go away - but I need seq inj....
Hope you can help, thanks.
Elior
DIYPNP v1.5
fw 341 (was 342)
seq inj
miata 97 turbo
I ran fw 332 and all was good then I had to upgrade to 342 and this error came up, I just re-flashed and it went away...
Yesterday I wanted to start tuning my newly installed EBC and I got this error after sending the MSQ from the laptop to the ECU...
Things I tried:
- Power cycle
- fw downgrade to 341 (choosing fw for DIYPNP)
- disable IAC
- new project
- disabling seq inj - make the error go away - but I need seq inj....
Hope you can help, thanks.
Elior
DIYPNP v1.5
fw 341 (was 342)
seq inj
miata 97 turbo
Reply
0
0
07-10-2016, 06:33 AM
#2
Senior Member
Thread Starter
Join Date: Nov 2012
Location: Israel
Posts: 650
Total Cats: -481
I noticed that the error comes on when the "boost control pin" is set to anything but "off".
Even is the whole EBC menu if off and the control pin is not off, the error will come on...
I wired ALED to control my EBC - as DIY instructed me to.
fw error ?
Even is the whole EBC menu if off and the control pin is not off, the error will come on...
I wired ALED to control my EBC - as DIY instructed me to.
fw error ?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
