Mspnp9093 Major Problemssssss!!!!!!!!!!!!!!!!!!!help
#1
Elite Member
Thread Starter
iTrader: (8)
Join Date: Oct 2007
Location: Dallas
Posts: 1,829
Total Cats: 0
Mspnp9093 Major Problemssssss!!!!!!!!!!!!!!!!!!!help
I was going to reflash the firmware. I did everything right. I checked the com port and it was com5. That is the only one that would work. I unhooked the coil ignitor on the fenderwheel. I clicked the firmware,Hit enter, enter again. selected com5. Then it said failed. I was on the phone with Matt. He said it was probably the serial usb cable. And it should be fine but I needed to get that straightened out.
I found out now why the com port won't work. The light on the MS won't come on. I don't think it has power.
Everytime I try to open megatune to check port. It its says msns-????? >boot ?????????in the message.
What do you think. Fuses are not blown.
I found out now why the com port won't work. The light on the MS won't come on. I don't think it has power.
Everytime I try to open megatune to check port. It its says msns-????? >boot ?????????in the message.
What do you think. Fuses are not blown.
#15
Elite Member
Thread Starter
iTrader: (8)
Join Date: Oct 2007
Location: Dallas
Posts: 1,829
Total Cats: 0
Hey guys, I installed my Iat sensor. I plugged the wires into the 1st and 6th. Then I downloaded no afm firmware. Downloaded the base map. Changed the o2 settings to wbo2. Turned the ms off. Plugged the in connector for the coils. Confetti was falling from the ceiling.......... And NO START.
I repeated again. Same thing.
I switched firmware and everything back to afm. It started.
Any suggestions?
I repeated again. Same thing.
I switched firmware and everything back to afm. It started.
Any suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
Jike Spingleton
Cars for sale/trade
3
09-20-2016 04:33 PM
StratoBlue1109
Miata parts for sale/trade
7
09-24-2015 03:50 PM