EBC works nice!
#1
Boost Czar
Thread Starter
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
EBC works nice!
check out this log.... I tuned out the dip in kPa you see...it's at 5600RPM at every gear, holds fairly flat at 190-192kPa.
I'm going through all gears, hitting about 100-110mph in 5th
Using the FM (ARO) solenoid with the same settings everyone is using for the GM device.
I'm going through all gears, hitting about 100-110mph in 5th
Using the FM (ARO) solenoid with the same settings everyone is using for the GM device.
#5
Boost Czar
Thread Starter
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
no, Fahrenheit (I'm All-American).
actually once I pulled out of the garage the IATs were 80°F (logs around 11:30am this afternoon)....so not bad....
but notice my CLT (it will drop when knock is detected)....suffice to say, I'm ordering the FM studs and calling it a day
actually once I pulled out of the garage the IATs were 80°F (logs around 11:30am this afternoon)....so not bad....
but notice my CLT (it will drop when knock is detected)....suffice to say, I'm ordering the FM studs and calling it a day
#7
I saw the CLT dropped like that and assumed you just hadn't tuned the knocksense yet. What is the best way to tune the KS anyway? Run the car to redline staying out of boost and tuning the KS so that no knock is detected that way under boost anything outside of normal engine noise would be considered knock.
#9
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
That's the reason why I don't recommend running the knock sensor to the clt line. It should be fine for a 3rd party logger, but it's not right for the ecu.
You can graph knock in MLV. It's a choice in the pull down menu with all the other stuff you can look at. So there's no reason to superimpose.
Ben
You can graph knock in MLV. It's a choice in the pull down menu with all the other stuff you can look at. So there's no reason to superimpose.
Ben
#10
Boost Czar
Thread Starter
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
yeah, I'm sure even with the knocksense's sensitivty perfectly tuned it will still spike in 1st down low whengoing around corners or launching...i would rather have a clean CLT line so I'll be removing it.
i just gotta play with it now and fine tune it, but im still not driving the car from lack of an o2 sensor...
i just gotta play with it now and fine tune it, but im still not driving the car from lack of an o2 sensor...
Thread
Thread Starter
Forum
Replies
Last Post