Rev. built MS3 suddenly won't idle, log included
#1
Rev. built MS3 suddenly won't idle, log included
I had the laptop hooked up, so I got a couple of logs. This isn't the 1st time it's happened, but every other time it quit before I could log. Every time I pushed in the clutch or let the rpms drop to less than @2300, the motor would begin cycling up and down from 2000 to 2500 rpms.
#4
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
That's the tune that you're running? What exactly are you doing with the table switching? Your VE3 table makes no sense.
Idle is being upset by your over run fuel cutoff. Your motor idles at a MAP that is below your trigger setting. Disable over run or set it to engage at a lower MAP.
Idle is being upset by your over run fuel cutoff. Your motor idles at a MAP that is below your trigger setting. Disable over run or set it to engage at a lower MAP.
#6
Had a few minutes to mess with the car. I disabled over-run and the rpms wouldn't drop below 2500. I pulled the Idle valve off the car to look for any leaks around the gasket or any obstructions inside, and everything looked fine. I had recently enabled the "initial map reading" for baro correction and I "included AFRtarget" in load parameters. I wouldn't think either one of those would cause this problem? Any other insights into the tune I'm running?
#7
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 856
Your iac duty cycle is way too high. This makes me think this: Mine did that when I was using the "use last value" for pre-setting the iac duty cycle. I fixed it by going to "Use initial value table" and then filling in the table with real values. That was for closed loop, but you may be using open loop, in which case 68 duty cycle seems very high to me, and could also be part of the problem.
I think I just repeated myself, but I'm leaving it.
I think I just repeated myself, but I'm leaving it.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM