Damaged Megasquirt PNP help please.
#1
Damaged Megasquirt PNP help please.
Ok, I've trolled long enough, after being a member since '07. So I traded Braytonia for this ECU and I knew it was "fried" so I figured at worst I'd be out only a a small amount. So on to the problem.
After pulling both boards I found 2 burned resistors (R15, R16) and lifted traces. Actually I'll be testing the resisters with my DMM because it could be that the trace beneath it burned and toasted the resisters exterior but either way I plan to replace them. 2nd issue is that it had no cable and no DB9 which I had expected.
Question 1: What are the pin outs for the db9 on the board? Only pins 2, 3, 5 and 9 are used in the PS/2 connector.
Question 2: What mods do I need to convert this 94-97 unit to 90-93?
***edit***
I've replaced the resistors and run a jumper wire to bridge the broken trace. All seems good to go.
After pulling both boards I found 2 burned resistors (R15, R16) and lifted traces. Actually I'll be testing the resisters with my DMM because it could be that the trace beneath it burned and toasted the resisters exterior but either way I plan to replace them. 2nd issue is that it had no cable and no DB9 which I had expected.
Question 1: What are the pin outs for the db9 on the board? Only pins 2, 3, 5 and 9 are used in the PS/2 connector.
Question 2: What mods do I need to convert this 94-97 unit to 90-93?
***edit***
I've replaced the resistors and run a jumper wire to bridge the broken trace. All seems good to go.
Last edited by Zel; 09-08-2012 at 04:12 PM. Reason: Being ignored.. Removed images.
#3
Ok, I've trolled long enough, after being a member since '07. So I traded Braytonia for this ECU and I knew it was "fried" so I figured at worst I'd be out only a a small amount. So on to the problem.
After pulling both boards I found 2 burned resistors (R15, R16) and lifted traces. Actually I'll be testing the resisters with my DMM because it could be that the trace beneath it burned and toasted the resisters exterior but either way I plan to replace them. 2nd issue is that it had no cable and no DB9 which I had expected.
Question 1: What are the pin outs for the db9 on the board? Only pins 2, 3, 5 and 9 are used in the PS/2 connector.
After pulling both boards I found 2 burned resistors (R15, R16) and lifted traces. Actually I'll be testing the resisters with my DMM because it could be that the trace beneath it burned and toasted the resisters exterior but either way I plan to replace them. 2nd issue is that it had no cable and no DB9 which I had expected.
Question 1: What are the pin outs for the db9 on the board? Only pins 2, 3, 5 and 9 are used in the PS/2 connector.
MSPNP Tune Cable DIYAutoTune.com
Question 2: What mods do I need to convert this 94-97 unit to 90-93?
***edit***
I've replaced the resistors and run a jumper wire to bridge the broken trace. All seems good to go.
***edit***
I've replaced the resistors and run a jumper wire to bridge the broken trace. All seems good to go.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM