TheV's

iTrader: (2)

Hi,

I'm bench testing my MS3x, looks like I have sequential spark output, RPM's look good, but the INJ1 and INJ2 or FIDL LED on the Jimstim are not lighting up. I have also noticed my Fuel Pump light is not going out after 2 seconds, it had been going off before but no longer seems to extinguish.

Couple of things I'd like to confirm

Jimstim
I'm not 100% sure how to setup the Jimstim to get the INJ1 and INJ2 & FIDL LED to light, I have run the jimstim LED test and they do work, should they be jumpered in some way to make them work or should they work without any jumpers needed ?

MS3X
There is a possibility I have not setup the right output, I have tried the test mode and just normal running and messed with a few different pulse widths etc...

Thanks - feeling my way through this, a little out of my comfort zone right now !

TheV's

iTrader: (2)

OK, now I'm answering my own posts.. Doh....Just found I had setup Main fuel outputs to be MSX3 instead of std....onto FIDL settings next...

Braineack

iTrader: (62)

Everything's on the expander, and everything works. Go install.