VICS in Brain-Built MS3
05-08-2015, 12:59 AM
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Location: Phoenix
Posts: 164
Total Cats: 6
VICS in Brain-Built MS3
I'm hoping you all can help with this, since I can't seem to get ahold of Braineack over email:
Does anyone know if Brain wires up his harnesses to support VICS control in 99-00 cars? If so, where do I control it from? I know there are several outputs, but wasn't able to figure out which (if any) are hooked to it.
Car is an N/A 99 with the stock motor.
Does anyone know if Brain wires up his harnesses to support VICS control in 99-00 cars? If so, where do I control it from? I know there are several outputs, but wasn't able to figure out which (if any) are hooked to it.
Car is an N/A 99 with the stock motor.
Reply
0
0
05-08-2015, 08:52 AM
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,483
Total Cats: 4,076
I thought we took care of this in the last msq i sent you? (but not sure how i missed your last few emails looking back--still need help regarding that issue?).
it should be INJ E under programmable inputs and outputs.
Active On
rpm > 5252 | 10
it should be INJ E under programmable inputs and outputs.
Active On
rpm > 5252 | 10
Reply
1
1
05-08-2015, 10:37 PM
#3
Junior Member
Thread Starter
Join Date: Dec 2010
Location: Phoenix
Posts: 164
Total Cats: 6
No worries, thanks! We did take care of the high idle issue with the last tune you sent, and I was able to fix the sync issue at high RPM yesterday, so it's looking pretty good at this point.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
