markooo89

So i bought a DIY kit MS2 and have soldered all the parts i want, but the instructions on DIYautotune are very vague.
Im now stuck at the part where i have to wire the connector board to the main board, and i have no clue how to read the jumper table on the DIY site. Any help or redirection to a full build tutorial that is more recent would be greatly appreciated. Ive searched everywhere but could only locate the old and outdated 3.0 board build by braineack. Mine is a 1.5b board

Braineack

iTrader: (62)

vague?

https://www.diyautotune.com/support/...5-mazda-miata/

this tells you EXACTLY how to populate the jumpers for the connector board.

examples: AIT to 4P, CLT to 4Q, TPS to 4M, etc.


I will concede the table use to be formatted better and it's hard to distinguish the different sections from each other.

markooo89

So the left column is for matching the jumpers got it. What are the other collumns for? Im a total newbie and tried to read up alot but electronics is just way over my head in terms of transistors, pull ups, etc.

Braineack

iTrader: (62)

do the edge pin connectors, pull-ups, and I/Os.

the trigger settings are software (and they provide a base map)

and the rest are unpopulated and unused.