tehzack

So i've got a new gremlin with the car. I went out to start it today and it just turned over and over and wouldn't start. I cycled the key to run and I noticed that the fuel pump primed like it usually does, but then primed again a couple more times. I hooked my laptop and I was presented with this upon opening tuner studio:




I tried starting a new project to reload the firmware and the car started up and ran fine. I went out to start the car a few hours later and now its giving me the same AC pin error/conflict message.

Reverant

iTrader: (10)

ALED is used for the A/C, what did you try to do that uses the ALED output?

Braineack

iTrader: (62)

wait, you cant set every output to ALED?

deezums

iTrader: (3)

You saw the thread where the other guy had his AC out set to CLT>98c?

lul