Sync loss 32 question

Reply Subscribe

Thread Tools

Search this Thread

12-19-2016, 08:08 AM

#21

freedomgli

Junior Member

Join Date: Jan 2007

Posts: 230

Total Cats: -23

Quote:

Originally Posted by DNMakinson

It would be nice if someone would post a good log shot.

There are 3 good examples in this thread alone. What are you hoping to see that you don't in the log screenshots already posted here?

12-19-2016, 08:48 AM

#22

DNMakinson

Retired Mech Design Engr

iTrader: (3)

Join Date: Jan 2013

Location: Seneca, SC

Posts: 5,009

Total Cats: 856

Quote:

Originally Posted by freedomgli

There are 3 good examples in this thread alone. What are you hoping to see that you don't in the log screenshots already posted here?

As I said, What Ian posted. All others were of bad logs.

I was not looking for a Good Shot of a Log, but rather a Shot of what a Good Log should look like.

In other words, both Crank and Cam with a lower baseline and pulses going up.

12-19-2016, 09:52 AM

#23

Braineack

Boost Czar

iTrader: (62)

Join Date: May 2005

Location: Chantilly, VA

Posts: 79,493

Total Cats: 4,080

even if the OP flips his cam polarity in software, it still might not run well cause the crank log looks fubared.

12-20-2016, 02:54 PM

#24

freedomgli

Junior Member

Join Date: Jan 2007

Posts: 230

Total Cats: -23

Quote:

Originally Posted by DNMakinson

As I said, What Ian posted. All others were of bad logs..

Did you over look the one I posted? NVM I see you edited your previous post.

12-21-2016, 10:30 AM

#25

joe morreale

Junior Member

Thread Starter

Join Date: Jun 2015

Location: Sebring, FL

Posts: 333

Total Cats: 20

Thanks to all that posted. The crank angle sensor needed replacing. $53 from Rock Auto for a Beck Arnley, delivered to my door. I just had to wait a few days. Runs fine now,