almost there! red leds?
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,022
Total Cats: 6,588
With your laptop attached and Megatune / TunerStudio running, do you see an RPM indication on the screen while you are cranking?
Take a datalog while you are turning the starter and post it up. Let's have an MSQ file as well.
Take a datalog while you are turning the starter and post it up. Let's have an MSQ file as well.
#3
Junior Member
Thread Starter
Join Date: Dec 2008
Location: Hamilton, Ontario
Posts: 89
Total Cats: 0
i should be using tunerstudio, obv correct? Im just going by a guide i found for the car...
http://www.boostedmiata.com/MS/msq/i...uctions_TS.pdf
It does run however now, ughm...It runs, then dies after approx 10 sec. idles high then stumbes and dies quickly.
http://www.boostedmiata.com/MS/msq/i...uctions_TS.pdf
It does run however now, ughm...It runs, then dies after approx 10 sec. idles high then stumbes and dies quickly.
#6
Junior Member
Thread Starter
Join Date: Dec 2008
Location: Hamilton, Ontario
Posts: 89
Total Cats: 0
still! turns out my lines were fine. Its still not working, wideband installed aswell.
It just leans out after 5-10 sec of idle, and dies.
What is going wrong?
I wired the fp to gnd thing , did i do smth wrong?
It just leans out after 5-10 sec of idle, and dies.
What is going wrong?
I wired the fp to gnd thing , did i do smth wrong?
#8
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
You're going to need to get your fuel tuning in order. There's several steps, so it's going to take a "manual sized" how-to:
http://www.msextra.com/doc/ms1extra/...ing_Manual.htm
http://www.msextra.com/doc/ms1extra/...ing_Manual.htm
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
russian
Miata parts for sale/trade
6
10-08-2015 03:01 PM