DIYPNP Help//Built but wont connect
#1
DIYPNP Help//Built but wont connect
soo heres whats going on..
built the DIYPNP, had never soldered before but i felt like i got the hang of it and got it done..i used the provided MS2/Extra command prompt firmware flasher thing and it doesnt detect the MS.
I have a 12v 500ma stim plugged in as well as a USB~Serial cord going into the computer with the port set to COM1 and still nothing..I watched a video that said to turn the buffers all the way down and still got nothing. What am i doing wrong? Does it look built correctly? I have the BOOT pin bridged and in also (not pictured)
At this point id really rather just send it to someone or take it somewhere local to SoCal and have them figure it out, im pretty spent on this whole endevour.
built the DIYPNP, had never soldered before but i felt like i got the hang of it and got it done..i used the provided MS2/Extra command prompt firmware flasher thing and it doesnt detect the MS.
I have a 12v 500ma stim plugged in as well as a USB~Serial cord going into the computer with the port set to COM1 and still nothing..I watched a video that said to turn the buffers all the way down and still got nothing. What am i doing wrong? Does it look built correctly? I have the BOOT pin bridged and in also (not pictured)
At this point id really rather just send it to someone or take it somewhere local to SoCal and have them figure it out, im pretty spent on this whole endevour.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM