Connect Megasquirt / Megasquirt PNP to dataloggers
#1
Connect Megasquirt / Megasquirt PNP to dataloggers
Can anyone help with some general info concerning the serial protocol from Megasquirt / Megasquirt PNP ?
I would like to feed the serial output from MSPNP to my Race-Technology DL-1 Data logger. R-T recently released a series of ECU connectors, including a generic serial adapter, but they need some information about the Megasquirt's serial data output to make it work.
According to R-T support, they need:
A detailed description of the data stream including checksums, marker bytes, standard data length, baud rate, etc. This is the basic data we require to enable us to decode the incoming stream.
Can anyone help with this info, or point me in the right direction?
Thanks in advance!
I would like to feed the serial output from MSPNP to my Race-Technology DL-1 Data logger. R-T recently released a series of ECU connectors, including a generic serial adapter, but they need some information about the Megasquirt's serial data output to make it work.
According to R-T support, they need:
A detailed description of the data stream including checksums, marker bytes, standard data length, baud rate, etc. This is the basic data we require to enable us to decode the incoming stream.
Can anyone help with this info, or point me in the right direction?
Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM