Pump pulses on and off ????
03-12-2007, 08:47 AM
#21
Elite Member
Thread Starter
iTrader: (1)
Join Date: Jun 2005
Location: Pikeville, TN
Posts: 3,038
Total Cats: 27
Ok, turned it about 10 turns clockwise - it still pulses?
Started backing it off and it pulses slower but doesn't stop?
What do I do...
Started backing it off and it pulses slower but doesn't stop?
What do I do...
Last edited by rmcelwee; 03-12-2007 at 09:55 AM.
Reply
0
0
03-12-2007, 11:24 AM
#22
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,026
Total Cats: 6,592
Rob- you've aroused my curiosity again about that pressure adjustment.
I've not fiddled with it, but my understanding is that it's an electrical pressure switch which interrupts the electrical feed to the pump when a preset head pressure is reached. Presumably adjusting the screw biases the switch mechanism in much the same way as the standalong switches used to control the pump on the base-level (non progressive) kits.
Perhaps it would be helpful for folks if somebody knows the approximate range of adjustment on the screw? In other words, it covers a range of X psi to Y psi, over a total of Z turns.
I've not fiddled with it, but my understanding is that it's an electrical pressure switch which interrupts the electrical feed to the pump when a preset head pressure is reached. Presumably adjusting the screw biases the switch mechanism in much the same way as the standalong switches used to control the pump on the base-level (non progressive) kits.
Perhaps it would be helpful for folks if somebody knows the approximate range of adjustment on the screw? In other words, it covers a range of X psi to Y psi, over a total of Z turns.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM
