3" ehaust cutout
03-30-2007, 04:37 PM
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2005
Location: South Carolina
Posts: 582
Total Cats: 0
3" ehaust cutout
selling my 3 inch exhaust cutout since i am just going to run straight 3 inch to the back now anyways. its mild steel and tig welded. includes the cap and wing nuts and gasket.
dosnt leak at all and just needs to be welded in. even after a good hard 10-15 min run the wing nuts are barely warm. takes about 30 seconds to uncap. noticed a huuge performance difference when i uncaped it to bypass my 2.25 inch muffler. spool up was much faster, power came soon and harder. i had it just behind my seat and it was not annoying at all. just make sure you put it behind you
35 shipped depending on your location pm me
dosnt leak at all and just needs to be welded in. even after a good hard 10-15 min run the wing nuts are barely warm. takes about 30 seconds to uncap. noticed a huuge performance difference when i uncaped it to bypass my 2.25 inch muffler. spool up was much faster, power came soon and harder. i had it just behind my seat and it was not annoying at all. just make sure you put it behind you
35 shipped depending on your location pm me
Last edited by mxv; 04-01-2007 at 12:51 AM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
