FS: 1st gen Silver 6ul's, Lotus Elise seats, clamps, and stuff
06-01-2012, 10:49 PM
#1
Elite Member
Thread Starter
iTrader: (18)
Join Date: Dec 2007
Location: oahu
Posts: 1,787
Total Cats: 6
FS: 1st gen Silver 6ul's, Lotus Elise seats, clamps, and stuff
All items are in CT. Shipping and paypal fees are not included unless otherwise stated.
Myriad of t bolt clamps. $3 each
Sizes and quantities:
7x 92mm-100mm
4x 87mm-95mm
2x 1.75"-2"
1x 48mm-56mm
Sticky pod (comes with 1 extra suction cup): $50
Side markers: $old
B6-BP throttle cable adapter plate with 90 throttle cable (~160K): $old
Turbo coolant inlet and outlet: $old
I also have a LC1 that randomly stopped working for me, it was wired directly to ecu power and ground. The sensor fouled up once and was cleaned with sensor/throttle body cleaner and worked fine after that (until the LC1 stopped playing nice). I didn't really care to dive into troubleshooting so I just replaced it but before I removed I did a quick voltage check to see if power was coming out of the controller (via a Fluke) going to the sensor and there was.
$old
First Gen 6UL's. 4x100 38mm backspacing. Autox'd them a few times and drove the car minimally. There are a few chips on the front drivers side wheel and the rear passenger side wheel. Other than that no bends, cracks, or curbages. Comes with the 949 valve stems, no lug nuts, no tires, no center caps. $old
You can see the chips along the edge of the wheel where the wheel and tire meet. I didn't even notice it until I was taking the pics for this.
Silver first gen 15x8 6UL's (4x100) wrapped in 205/50/15 Dunlop Direzza Sport Z1's: $old
Lotus seat set with inflatable lumbar and miata brackets: $old
I'm also open to trades.
Myriad of t bolt clamps. $3 each
Sizes and quantities:
7x 92mm-100mm
4x 87mm-95mm
2x 1.75"-2"
1x 48mm-56mm
Sticky pod (comes with 1 extra suction cup): $50
Side markers: $old
B6-BP throttle cable adapter plate with 90 throttle cable (~160K): $old
Turbo coolant inlet and outlet: $old
I also have a LC1 that randomly stopped working for me, it was wired directly to ecu power and ground. The sensor fouled up once and was cleaned with sensor/throttle body cleaner and worked fine after that (until the LC1 stopped playing nice). I didn't really care to dive into troubleshooting so I just replaced it but before I removed I did a quick voltage check to see if power was coming out of the controller (via a Fluke) going to the sensor and there was.
$old
First Gen 6UL's. 4x100 38mm backspacing. Autox'd them a few times and drove the car minimally. There are a few chips on the front drivers side wheel and the rear passenger side wheel. Other than that no bends, cracks, or curbages. Comes with the 949 valve stems, no lug nuts, no tires, no center caps. $old
You can see the chips along the edge of the wheel where the wheel and tire meet. I didn't even notice it until I was taking the pics for this.
Silver first gen 15x8 6UL's (4x100) wrapped in 205/50/15 Dunlop Direzza Sport Z1's: $old
Lotus seat set with inflatable lumbar and miata brackets: $old
I'm also open to trades.
Last edited by astroboy; 06-18-2012 at 05:22 PM. Reason: Added wheels and seats
Reply
0
0
06-11-2012, 10:02 AM
#20
Elite Member
Thread Starter
iTrader: (18)
Join Date: Dec 2007
Location: oahu
Posts: 1,787
Total Cats: 6
No tears/rips in the seats, there are 2 spots that I would like to treat because the black is faded (where the seatbelt strap goes across the lap). The rails are custom deals. I would be willing to ship anywhere.
Reply
0
0
