Bipes, Fuel Pump and Injectors
#1
Elite Member
Thread Starter
iTrader: (14)
Join Date: Mar 2006
Location: Edmonton, AB
Posts: 4,908
Total Cats: 1
Bipes, Fuel Pump and Injectors
Had lots of interest, but no one came through. So I have the following still forsale:
Bipes with v1.5 chip: SOLD
MSD 2225 Aux Inline Pump: SOLD
http://www.msdignition.com/fuel_7.htm
Injectors SOLD.
All items were installed in my car until recently and were working. With an AFPR and these items you should be able to do 8-10psi. I ran about 7-9psi and was running rich on the dyno.
The fuel pump is similar to the one that FM and BEGI included in their turbo kits, was able to supply over 125psi. I had trouble with my OE pump and went to a Walbro intank solution.
I think the prices are good, if you think otherwise make an offer.
Jay
jason.clements (at) shaw.ca
Bipes with v1.5 chip: SOLD
MSD 2225 Aux Inline Pump: SOLD
http://www.msdignition.com/fuel_7.htm
Injectors SOLD.
All items were installed in my car until recently and were working. With an AFPR and these items you should be able to do 8-10psi. I ran about 7-9psi and was running rich on the dyno.
The fuel pump is similar to the one that FM and BEGI included in their turbo kits, was able to supply over 125psi. I had trouble with my OE pump and went to a Walbro intank solution.
I think the prices are good, if you think otherwise make an offer.
Jay
jason.clements (at) shaw.ca
Last edited by jayc72; 10-05-2006 at 01:07 PM.
#6
Hey Jay,
Just wanted to let you know that I just received the FM o2 clamp in the mail. Thanks for the instructions. I hope I can figure this out since I have a 1990 and the instructions are for 1996 and up. Again, thanks for your time.
Regards, Henry
Just wanted to let you know that I just received the FM o2 clamp in the mail. Thanks for the instructions. I hope I can figure this out since I have a 1990 and the instructions are for 1996 and up. Again, thanks for your time.
Regards, Henry
Thread
Thread Starter
Forum
Replies
Last Post