FS:Toyota COPs + pins and cap
12-31-2010, 11:32 PM
#1
Junior Member
Thread Starter
iTrader: (7)
Join Date: Feb 2007
Location: Overland Park, KS
Posts: 394
Total Cats: 6
FS:Toyota COPs + pins and cap
$40 Shipped CONUS
These are longer than the Toyota COPs most people on MT.net use, therefore they do not sit down flush with the valve cover.
The pins and high temp capacitor were supplied by Braineack.
There are enough pins to make two harnesses. Just grab some connectors (Toyota P/N 90980-11885) and you are ready to build a custom COP setup.
Connectors can be purchased here: http://www.discounttoyotaparts.com/
These are longer than the Toyota COPs most people on MT.net use, therefore they do not sit down flush with the valve cover.
The pins and high temp capacitor were supplied by Braineack.
There are enough pins to make two harnesses. Just grab some connectors (Toyota P/N 90980-11885) and you are ready to build a custom COP setup.
Connectors can be purchased here: http://www.discounttoyotaparts.com/
Last edited by MazDilla; 01-08-2011 at 01:08 PM.
0
01-08-2011, 05:37 PM
#4
Newb
Join Date: Nov 2010
Location: Las Vegas, Nv.
Posts: 17
Total Cats: -1
How high above the valve cover do they sit?
0
01-08-2011, 06:46 PM
#5
Junior Member
Thread Starter
iTrader: (7)
Join Date: Feb 2007
Location: Overland Park, KS
Posts: 394
Total Cats: 6
10,000 micro Farads
16V
105 degrees C
I put them on the car and snapped a pic just for you. You could trim the boots if you want them to sit lower. Also a hold down bracket would also cover this space and make them sit nice and flush.
16V
105 degrees C
I put them on the car and snapped a pic just for you. You could trim the boots if you want them to sit lower. Also a hold down bracket would also cover this space and make them sit nice and flush.
0
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
