FS: APR GTC-200 Uni.Adj. + RainRail Bracket - $650
#22
I have a never installed, Braineack built, DIYPNP. It's an early build, I think a v1.1 board with the sequential injection module added.
I'd be using this on a non-Miata application. Can you tell me the distance between the mounting legs/stantions?
I'd be using this on a non-Miata application. Can you tell me the distance between the mounting legs/stantions?
#23
Senior Member
Thread Starter
iTrader: (4)
Join Date: Apr 2011
Location: Bay Area CA
Posts: 542
Total Cats: 17
Ok thanks for the offer, I will keep that in mind. I can measure it tomorrow. I will provide the distance from bolt hole to bolt hole on the apr legs(on bottom) as well as the inside edge to edge of the legs. The wing has 4 seperate square pads that can bolt to said holes witch provides the legs, say a 2" square base, 2 on both legs. I can measure the inside edges of said pads as well if needed. IIRC the legs should be either 32" center to center, or other location, I belive is 42". That would be center to center. I will confirm tomorrow.
#25
Senior Member
Thread Starter
iTrader: (4)
Join Date: Apr 2011
Location: Bay Area CA
Posts: 542
Total Cats: 17
ok I got the measurements from inside edge to edge. Starting at the leading edge, 41.5, rear edge is 42". I was rushed out of the shop and didnt get the pcd of the mouting holes on the legs. But iirc that should be about 42" at the leading side, and 42.5" at the rear. With the pads on, the inside distance drops to 39.5".
Chili - yes 1.6er
Chili - yes 1.6er
#26
ok I got the measurements from inside edge to edge. Starting at the leading edge, 41.5, rear edge is 42". I was rushed out of the shop and didnt get the pcd of the mouting holes on the legs. But iirc that should be about 42" at the leading side, and 42.5" at the rear. With the pads on, the inside distance drops to 39.5".
Chili - yes 1.6er
Chili - yes 1.6er
#28
I'd be willing to add some cash to the deal but not a whole lot. Someone linked a vendor in this thread selling the same wing for $610 brand new with free shipping. Your pre-drilled mounts wouldn't be useful to me because I won't be using the wing on a Miata.
#30
If still available, please PM me.
Thread
Thread Starter
Forum
Replies
Last Post
mikeflys1
Miata parts for sale/trade
15
10-27-2018 02:19 PM
chris101
Miata parts for sale/trade
2
10-09-2015 09:08 AM