1.6 Turbo Setup FS
01-29-2009, 04:47 PM
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Oct 2007
Location: Fremont, CA
Posts: 172
Total Cats: 0
1.6 Turbo Setup FS
I have a turbo/manifold/DP setup for sale.
Cast Iron Manifold - Not sure manufacture. I think it's first generation FM/Begi with relief cuts in between 1/2 and 3/4.
Hairline crack between exh port 1-2 and port 2-3. I believe it's weldable if you preheat the manifold in an oven to 500+degree, welding it, and then droping it in some sand to let it cool slowly. I can do it, but i think the buyer should get it done so quality of the weld can be assured. Some more pictures of crack when i get home.
Adaptor Plate T25-to-16G turbine inlet - The manifold outlet has been ported to the adaptor plate.
Big Wheel 16G turbo - Minimal Shaft play. Spools a little slow for me. I was running it at 18 psi on a motor with low compression pistons. I can include a -3an stainless line for the oil inlet and a silicon line for the oil outlet. I reused the water lines for my new GT2560R turbo.
Divorced Half-Downpipe It's a half-downpipe. it ends at that flange. O2 Bung at the bend. I believe the DP is 2" until the flange.
How does $500 plus shipping sound?
Cast Iron Manifold - Not sure manufacture. I think it's first generation FM/Begi with relief cuts in between 1/2 and 3/4.
Hairline crack between exh port 1-2 and port 2-3. I believe it's weldable if you preheat the manifold in an oven to 500+degree, welding it, and then droping it in some sand to let it cool slowly. I can do it, but i think the buyer should get it done so quality of the weld can be assured. Some more pictures of crack when i get home.
Adaptor Plate T25-to-16G turbine inlet - The manifold outlet has been ported to the adaptor plate.
Big Wheel 16G turbo - Minimal Shaft play. Spools a little slow for me. I was running it at 18 psi on a motor with low compression pistons. I can include a -3an stainless line for the oil inlet and a silicon line for the oil outlet. I reused the water lines for my new GT2560R turbo.
Divorced Half-Downpipe It's a half-downpipe. it ends at that flange. O2 Bung at the bend. I believe the DP is 2" until the flange.
How does $500 plus shipping sound?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
