FS: Two gauge mounting options and PNP RX-7 460cc injectors
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Oct 2011
Location: Horse and Buggy, PA
Posts: 704
Total Cats: 21
FS: Two gauge mounting options and PNP RX-7 460cc injectors
I've changed my mind on a couple things since starting to accumulate parts for my build. Now I need to sell some of these extras so I can keep buying more parts that I actually need.
1. RX-7 460cc injectors - These are high impedance (aka Red Top #195500-2010) PNP for your miata. I bought these off a forum member with the intent to get them cleaned and flow tested, but have since decided to go with 550cc injectors. SOLD!!!
2. Dual A-pillar mounted gauge pod. Not new, but pretty decent shape. I don't have any mounting hardware. $25 shipped.
3. NB HVAC retrofit parts - this is a method I saw over on m.net. Basically you remove the NA HVAC controls and fab your own gauge plate to go in that spot. Then you install the NB HVAC controls either above or below the radio.
I already purchased a used NB HVAC panel and NB pigtail to make wiring it easier. The HVAC panel includes the cables which fit perfectly in the NA. $50 shipped for the HVAC controls and pigtail.
This is the thread on how to do the swap:
NB HVAC controls INSTALLED in NA - MX-5 Miata Forum
The end product should look something like this:
1. RX-7 460cc injectors - These are high impedance (aka Red Top #195500-2010) PNP for your miata. I bought these off a forum member with the intent to get them cleaned and flow tested, but have since decided to go with 550cc injectors. SOLD!!!
2. Dual A-pillar mounted gauge pod. Not new, but pretty decent shape. I don't have any mounting hardware. $25 shipped.
3. NB HVAC retrofit parts - this is a method I saw over on m.net. Basically you remove the NA HVAC controls and fab your own gauge plate to go in that spot. Then you install the NB HVAC controls either above or below the radio.
I already purchased a used NB HVAC panel and NB pigtail to make wiring it easier. The HVAC panel includes the cables which fit perfectly in the NA. $50 shipped for the HVAC controls and pigtail.
This is the thread on how to do the swap:
NB HVAC controls INSTALLED in NA - MX-5 Miata Forum
The end product should look something like this:
Last edited by RedCarmel; 12-14-2012 at 12:00 AM.
#8
Senior Member
Thread Starter
iTrader: (7)
Join Date: Oct 2011
Location: Horse and Buggy, PA
Posts: 704
Total Cats: 21
That's a good question. It came off a car that had an FM kit, but I don't know for sure if that means its miata specific. When I've held it up to my A piller it seems to match the contours fine.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM