wrxnova

iTrader: (10)

Trying to clean storage unit out so I can switch into smaller unit. I want all this crap gone ASAP. Located in Springfield, VA.

1.6 parts have around 95k and 1.8 parts have around 55k on them.

Braided Oil feed line - SOLD

1.8 Brake Booster - 25 + shipping

1.8 Starter - 30 + shipping

1.8 cruise control assembly - 20 + shipping



Turbo Catback exhaust with Cat welded in. Used in my 1.6 for a little less than 10k miles - 150 + shipping



38mm External wastegate w/ mounting flange - 50 + shipping

Passenger side turn signal assembly - 15 + shipping

1.8 Power steering pump - 20 + shipping

1.6 Fuel pump - 10 + shipping

Brake master cylinder - 20 + shipping

Wiper motor - 15 + shipping

Coolant reservoir - 15 + shipping

1.8 coil and wires (look brand new and never tested were on a wrecked miata w/ 55k I bought 9 months ago) prefer to sell locally so they can be tested prior - 25 + shipping



1.6 flywheel and flywheel bolts - 40 + shipping



Universal Coolant reservoir - 10 + shipping

Prosport Oil pressure gauge - green/white - 20 + shipping

BNIB Thermo hose sleeves - SOLD

Internal wastegate actuators from WRX td04 turbos - 10 each + shipping

Clutch Master cylinder (55k from a 95) - SOLD

Intake Filter - 10 + shipping



Center consoles - 20 each + shipping



99 Intake manifold with hoses, throttle body, egr block off plates, etc. - 100 + shipping

Variable Throttle position sensor (VTPS) - from a 95 ford v8, mounting plate included which lines up with a 1.6's tps mounting holes. - 30 + shipping




Front Lower Control Arms - 20 each + shipping


OE Jack - 10 + shipping

Evap Canister - 10 + shipping

OE Jack - 10 + shipping

Rear Lower Control arms - 20 each + shipping

jasonrobo02

iTrader: (13)

1. I can't tell much from the pictures, so could you please elaborate on the braided oil line for $10. I'm looking for one that will go from the oil feed location on the 90-95 blocks and will attach to my T25 turbo. It's tough to tell, but it looks like one end is a 90* to -4an? and the other end has male threads of some sort.

2. What are the thermo-sleeves sized for? Are they sized for the turbo oil/water lines or are they larger in diameter?

bogaut

iTrader: (3)

what kind of external wastegate is it?

wrxnova

iTrader: (10)

Ill have to find and measure the oil feed line. Ill let you know.

The thermosleeves would fit hoses up to 3/4in. I should double check though... probably should have done this prior to posting, sorry.

Ebay special 38mm.

atli126

Is the cruise stuff all there my R doesn't have it at all

jasonrobo02

iTrader: (13)

Thanks for the update.

Milky

iTrader: (1)

what muffler was used with the exhaust? also what size is the piping?

wrxnova

iTrader: (10)

Just whats in the picture is what I intended on selling. I still have the cruise switch installed in my car (but do not use) I could pull it if thats what you need. LMK.

2.5" ID. Dynomax Turbo muffler IIRC.

atli126

I'm looking to get the whole cruise setup with wiring and all

wrxnova

iTrader: (10)

bump