wrxnova

iTrader: (10)

Bought a wrecked 1.8 (with 55k on it) to fund my turbo build and decided at same time to clean the garage out. All the 1.6 parts were pulled with 95k miles on them. Everything except big (not shippable) items are for sale exclusively to this forum. Buy my stuff!!!!

Things I need and will trade for :

1.8 timing cover
1.8 (Brand new only) Built Internals
Water Injection kit
'01+ head
3.90 or 4.10 torsen (guts only)

Pickup is prefered but will ship ANYTHING at your expense in the U.S.



Rear Bumper - 100 + shipping



Dash - 75 + shipping



Windblocker - 30 + shipping



Complete 1.6 airbox setup - 20 + shipping



1.6 AFM - 20 + shipping

RX7 AFM (painted black) - 30 + shipping

2x Coolant Reservoir - 15 each + shipping

Windshield washer pump and tank - 25 + shipping

1.6 Fuel Pump (95k miles) - 10 + shipping

Ebay External wastegate w/ flange - 50 + shipping



Hardtop brackets - SOLD

Turn Signal set - 30 + shipping

passenger side turn signal - 15 + shipping

1.8 ECM - 50 + shipping

1.6 ac compressor (95k miles) - 30 + shipping

1.8 Coil pack (not sure if it works) - 10 + shipping



OE Jack - 10 + shipping

Rear Lower Control arms - 20 each + shipping

1.8 Evap Canister - 10 + shipping



1.6 OE Fans - 10 each + shipping

Center console (I have 2) - 20 each + shipping

1.8 Clutch Master Cylinder - 20 + shipping

1.8 Brake Master Cylinder - 20 + shipping

1.8 Power steering pump - 20 + shipping

BOV Flanges - 5 + shipping



Center trim surrounding - 15 + shipping

1.8 Flywheel - SOLD

Black Glove box - SOLD

Dimmer Switch - 10 + shipping



OE 1.8 Front sway bar - 20 + shipping

Power Steering Rack - 100 + shipping

OE Seat Sliders/Brackets - 10 each + shipping



Front Lower Control Arms - 20 each + shipping



Aftermarket tail light set - SOLD



Floor Mats - 10 for both + shipping



Sun Visor set - 10 + shipping



1.8 Blower motor - 20 + shipping



1.6 Heater core - 20 + shipping

1.8 heater core - 20 + shipping



AC Heater control unit - SOLD



1.8 Fuel pump / sending unit - 30 + shipping



Seat belt set - 20 + shipping



Air vent pod - 5 each + shipping



Smoked Front side markers - 20 + shipping



Big Items I have pics available at request.

Driver side door - complete (manual window, mirror, door panel, tinted (prolly 35%) - SOLD

Passenger side door -complete (manual window, mirror, door panel, tinted (prolly 35%) - 100

Will strip doors if get enough interest in panels/skins seperate

Gas Tank - 50

Open 4.10 Diff (carrier only) no axles or driveshaft- 100

Turn Signal Intakes TSI - SOLD

Front Sub Frame - SOLD

Rear Sub Frame - SOLD

5 speed transmission - SOLD

AC Compressor - SOLD

Finish Panel - SOLD

Rear wingless trunk lid (good condition) - SOLD

Soft Top - SOLD

Passenger side tail light - ( good condition ) -SOLD

1.6 Valve Cover - (Painted Silver w/ aerosol) -SOLD

All 4 Spindles - SOLD

Front Upper control arms - SOLD

Engine Wiring harness - SOLD

1.8 exhaust header- SOLD

1.8 exhaust mid pipe - SOLD

Carpet - SOLD

Sun Visor set - SOLD

Faeflora

iTrader: (2)

Is there any blood on the seats?

wrxnova

iTrader: (10)

Just a little period blood.

KPLAFIN

iTrader: (1)

I wonder if this is my old car... Where was it from in VA?

wrxnova

iTrader: (10)

Vienna, VA.

Venice

iTrader: (2)

Pm me if you willing to part with the driver side QP an a price .

I might have a 1.8 valve cover to trade as well

wrxnova

iTrader: (10)

Sure... gonna have to do figure out how to remove nicely though. Where you located?

Venice

iTrader: (2)

Triangle Quantico i was going to ask about the rad support till i seen the left head light up close to the windsheilf an the fender pealed back like a banana....

wrxnova

iTrader: (10)

Local F yea! Yea all the front end stuff thats gone is trashed. Lemme figure out what I gotta do to remove it and we can figure something out. Also, I have a truck and go to that area weekly for work so we can definitely work something out.

Venice

iTrader: (2)

Cool let me know i'm getting tired of wiping out the water in my trunk an looking at the huge ******* dent i have covered with ducktape so it dont look like total **** .

Zabac

iTrader: (39)

What do the front upper control arms look like? Are the ball joints in good shape?
And all spindles?
I can work something out shipping/pick-up wise...

RyanRaduechel

iTrader: (10)

did the car have ac? Looking at the picture, I am going to guess no but I just want to make sure. If not let me know how much for the heater/blower controls inside. Mine is fadded and the light shines through at night time. I will take a picture of what I am referring to if I didnt make any sense

thanks,
Ryan

miatamike203

Is there a clean title at the moment

wrxnova

iTrader: (10)

Dunno, why?

wrxnova

iTrader: (10)

AC condenser and lines are trashed, compresser appears fine.

RyanRaduechel

iTrader: (10)

sorry, I meant the heater controller inside the car, I was asking if it had A/C or not because my car is non A/C and was looking for a heater controller without A/C.

magnamx-5

iTrader: (7)

becouse he could turn it into a race car easily.

wrxnova

iTrader: (10)

Wirelessly posted

I\'ll run a carfax tomorrow. But would assume they collected insurance money on crash.

SlideRuler

why, WHY does it have to have POWER steering?!

Zabac

iTrader: (39)

still interested in control arms and spindles...