turbo 1.6 pieces
#1
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
turbo 1.6 pieces
Ok i would like to make a package deal for my b6t that i was going to build before i got my bpt. I had picked this engine up from a felow ff.com member long ago. I was told the block has already been machined to fit the pistons, im not sure on how to verify this if you know how to let me know. The motor comes with a set of low compression weisco pistons and rings, clevlite bearings, new water pump, 1 1/2 complete federal mogual gasket sets, 1 miata intake manifold ( i was going to do like cam waugh) 1 set of injectors ( im not sure if there good or not got them from the j yard) 1 knock box, XR2 rods ARP head bolts and rod bolts. GTX manifold it has a crack by the 02 sensor which most d0, a good welder could probably fix it. Ill through in a New ram clutch too, ported and cleaned head, new water pump.
im sure theres more parts too that i havent listed i have about 4 bins and i only took pics from 2 bins
for the above i would like to get 1000 but im willing to take some off for the ARP stuff i can use that for my BPT
i have more stuff, my camera died so i will try to get pictures, feel free to ask questions
im not sure of the compression ratio but i took a pic of the spec sheet if someon knows please let me know.
This is all i can think of for now but im sure theres more
A few things you would need to make it a complete long block and be able to drop in a festy is
Turbo
Timming belt
Starter ( i may have a used one)
wirring
i have about 4 bins of stuff so i would perfer local pick up or maybe could meet with in a reasonable distine and cover some gas $$
Thanks
Rick
trans ( i have a parts g25mr)
im sure theres more parts too that i havent listed i have about 4 bins and i only took pics from 2 bins
for the above i would like to get 1000 but im willing to take some off for the ARP stuff i can use that for my BPT
i have more stuff, my camera died so i will try to get pictures, feel free to ask questions
im not sure of the compression ratio but i took a pic of the spec sheet if someon knows please let me know.
This is all i can think of for now but im sure theres more
A few things you would need to make it a complete long block and be able to drop in a festy is
Turbo
Timming belt
Starter ( i may have a used one)
wirring
i have about 4 bins of stuff so i would perfer local pick up or maybe could meet with in a reasonable distine and cover some gas $$
Thanks
Rick
trans ( i have a parts g25mr)
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM