cyotani

iTrader: (8)

After a few years of research and part accumulation I have come to realize as long as I'm in college this turbo build is not going to happen. I think I'll just be keeping my miata NA for the time being until I get a job and have more stable funds.


[U]PRICE DROP ON MANY ITEMS (2/1/13)


All parts located in Pomona, CA 91766
(808)561-8206- TEXT PREFERRED! (my PM box gets filled too fast)
Will ship smaller items at buyers expense
shoot me an offer on anything. worst I can say is no.


There was enough interest in individual parts that I will start parting out the turbo kit


PENDING PARTS:
-Intercooler and pipping with bov and filter.

SOLD PARTS:
-1.6 Dashboard
-trunk carpet
-begi manifold
-begi downpipe
-DIYPNP
-IAT sensor
-BMW TPS
-1.6 AFM
-oil/water lines
-spacers
-1.8 cross over tube
-sr20 turbo + turbo flanges
-1 piece sun visors
-hard top brackets
-AEM Wideband
-LC1 wideband




$40- Greddy Oil Sandwhich adapter with feed line (from a Honda, please check fitment capability)



$40- Catch can with filter


SOLD- Aem wideband with air fuel ratio gauge


SOLD- Inovative LC1 wideband with gauge

SOLD- DIYPNP for 90-93 Miata (comes with USB adapter)

SOLD- BMW VTPS for megasquirt
SOLD- IAT sensor kit from DIYPNP with steel bung (BNIB)
$35- EBC electronic boost control solenoid kit from DIYPNP


$40- Autometer boost gauge


$190- RC 550cc injectors


SOLD- 1 piece sun visor pair

$30- 1.6 coil pack
$40-1.6 oil pressure sendor


$30- black seat belt set with retainers


SOLD- 3/4 in spacer (pair only)
$20 pair- soft top latches
$10- shifter
SOLD- hard top brackets with bolts
$70- quick release for steering wheel
$35- side mount brackets to attach sparco/bride to oem rail (4 corners for 1 seat)
$5 each- AC eye ball vents


$20- 1.8 gauge cluster


$20-driver side air bag
$5- fake air bag cover
$20- aftermarket radio antena
$20- wire harness from trunk to engine bay with fuse box
$10- turn signal, headlight, wiper arm assembly
$10- air bag clock spring
$30-1.6 5spd ecu
$40-1.8 5spd ecu
$5 pair- light bulb with pig tail assembly
$1-$5- msc fuses, relays, etc.



SOLD- oil feed and return and coolant lines (all stainless)


PENDING- intercooler with bracket for miata with piping originally used for rotrext supercharger kit
- comes with rotrex recirculating blow off valve, iat sensor already tapped, filter, etc.


$250- oil cooler and filter relocation kit (no picture yet)


SOLD-BEGI 1.6 log manifold
SOLD- BEGI 1.6 downpip
SOLD- 2 bolt inlet and 3 bolt outlet adapter flanges
SOLD- sr20 garrett turbo with wastegate actuator (no shaft play)
$50- turbo heat shield



$450- 3 in exhaust with dynomax muffler (very quiet for turbo cars) cost $800+ to make



$40- clutch slave with complete hard and soft line to the clutch master


$40- driver side british racing green fender with a bad roll (not pretty but works fine)
$20- driver side door cover with arm rest


$30- 1.8 AFM
SOLD- 1.6 AFM with box
$20- cross over intake tube (1.6 available)
$15- climate control box
$10- clutch master cylinder
$5- clutch pedal
$10- brake master cylinder


$80- steering column with ingntion tumbler + 2 keys + matching door locks + trunk lock (replace your all you locks if broken into)


$15- power plant frame
$50- steering column with ignition tumbler and matching key
$10- sway bar (front or rear)
$20- misc chassis bracing pieces (all three on right side of picture)


SOLD- trunk carpet
$20- floor mat
$20- rear carpet pieces (pair)


$60- GAB 8 way adjustable shocks with bump stops (probably need a rebuild)


$80- oem complete suspension still assembled (no pic yet)

$30- 1.6 header
$5 each- heat shield (1.6 or 1.8)


$30- tan toneau (spelling?) cover (has a few small holes
$30- tan soft top cover in good shape


$30- 5spd radiator (no leaks)


$520- Konig Flatout 15x8 +25 with flaken tires 60% thread (one tire isn't holding air)



$20- miata daisy with bad tire
$5 each- daisy center caps


$30- oem cat back
$50- oem exhaust from 1.6 downpipe to muffler tip (includes cat) all welded together


$10 each- front 1.6 caliper
$20 each- rear 1.6 caliper


$30- power steering pump + resivor + lines
$20- cruise control module
$20- starter


$30- complete headlight assembly (bracket + lid + light + motor) one red one grey
$5- gas tank lid


$20- AC condensor with evap/dryer
$10- heater core
$10- AC blower motor
$20- AC compressor


$50- driver side door complete with glass and manual window regulator



SOLD- 1.6 black dash (lighter than 1.8 to save weight)

$25- engine stand (not the prettiest but gets the job done)


$80- seats with sliders in pretty good shape


$80- tan leather seats, no sliders, driver side has a rip


$220- sparco seat in good condiition


$50- 1.6 drive shaft
$45- rear control arm pair
$40- rear sub frame
$10- upright/knuckle with good wheel bearing
$30- 1.6 rear axel


$190- RX7 clutch type limited slip differential (no carrier)


$30- undercover panels



text preferred: (808)561-8206

Fireindc

iTrader: (13)

Sell just the braided water lines and oil drain? don't need the feed. If so, how much?

Yanballs

iTrader: (1)

Will buy the coolant and oil feed and return lines, pm me, also curiou about intercooler piping and Freddy oil filter sandwich

RedCarmel

iTrader: (7)

texted about heat shield

crono36

texted you about the 1.6 afm/airbox.

WooDooUK

Do'h Cant PM due to post count, :(

Would you be willing to post the MS to the UK?
If you can i will take some other bits aswell.

Cheers,

moolb

iTrader: (1)

Texted you yesterday about various parts

albumleaf

iTrader: (7)

Who built the DIYPNP? Has the car run on the unit?

cyotani

iTrader: (8)

I'm not sure who built it but it was pulled from a running 1.6 turbo miata. I have the excel sheet on how it was wired and can send it to you. If your interested PM me your email.

gtlee77

iTrader: (4)

PM sent for the BEGi log manifold and downpipe. Does the downpipe have the 2.5" flange or the 3"?

redturbomiata

iTrader: (5)

PM sent about turbo.

viperormiata

iTrader: (24)

PM sent on wiring harness

and texted!

cyotani

iTrader: (8)

All texts/pm's replied

parting out the kit now.

also have megan EZ streets with less than 2k miles usage for $600. pretty much a brand new set.

moolb

iTrader: (1)

Just texted again. thanks, Dave

motormechanic

iTrader: (1)

can you ship the 1.8 intake crossover tube?

cyotani

iTrader: (8)

yes, I can. $35 shipped and its yours. text or PM me if you want it.

cyotani

iTrader: (8)

oil lines, spacers, 1.8 cross over tube sold!.

all order placed by tonight will be shipped out tomorrow with tracking numbers.

atli126

do you have any more pics of the konigs installed? also what size tires and what are they?

cyotani

iTrader: (8)

konig flatout 15x8 +25 offset with falken ziex 195/50/15 tires (one needs to be replaced)

This is the only pic of them installed on my car but google is your friend to find many more pictures of the set up.

atli126

thanks im thinking of running these with big flares, are you willing to sell and ship them without tires? how much shipped to 40216