Megasquirt 2 3.57, wiring harness, tuning cable, and EBC solenoid
05-10-2015, 11:09 PM
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Livermore, CA
Posts: 138
Total Cats: -18
Megasquirt 2 3.57, wiring harness, tuning cable, and EBC solenoid
This is a pretty much brand new megasquirt 2 3.57 board, plus a 24" wiring harness, a tuning cable, an electronic boost control solenoid, and a female plug which plugs into the stock wiring harness allowing you to make this a PNP unit. The board has had the modifications described in the "how to megasquirt your miata" article.
I never was able to get an RPM signal with this, though I'm 99% sure the issue was in my wiring from the harness to the female plug. Nevertheless, I'm selling this as-is and you may need to redo some of the modifications I made. You will definitely have to redo the wiring to fit your application. I finally gave up and bought a MSPNP so I just need to sell this one. The price for all these parts new was close to $600, I'm selling for $450 shipped.
I never was able to get an RPM signal with this, though I'm 99% sure the issue was in my wiring from the harness to the female plug. Nevertheless, I'm selling this as-is and you may need to redo some of the modifications I made. You will definitely have to redo the wiring to fit your application. I finally gave up and bought a MSPNP so I just need to sell this one. The price for all these parts new was close to $600, I'm selling for $450 shipped.
Reply
0
0
06-26-2015, 10:09 PM
#10
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Livermore, CA
Posts: 138
Total Cats: -18
It's in the "how to megasquirt your miata" article. Just a couple resistors/jumper wires added to set it up to control the miatas electronics. You'll need to read that article if you're planning to install this anyway.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
