FS: SoCal: na8 motor, nb torsens, etc.
#1
FS: SoCal: na8 motor, nb torsens, etc.
We are currently tearing down Tony's miata, so we have parts up for sale. We are NOT PARTING OUT the car, we are rebuilding it, next phase!
---------------------------------------
94-95 Turbo "Kit"
NA8 Intercooler setup:
2.5" piping on both cold side and hot side
Cold side has pipe for IAC
Cold side has bung for IAT
Comes with all silicons and t-bolt clamps
Designed for HKS manifold with t25/28
^no AC/PS
Blitz Blow Off Valve
-New Venturi Drive
Intercooler
^Core 21.5" x 9.5"
^^Overall 28" x 9.5"
Turbo 3" downpipe
-custom 2piece
--v-band setup
-no divorce
Turbo 3" exhaust setup
-fully custom
--two resonators
---quiet large muffler
--electronic exhaust cutout
Only parts needed to complete the turbo setup of how it was originally on tony's car are:
--t25/t28 turbo
--HKS manifold
Original cost of parts:
Aluminum Intercooler Pipes: $350
Intercooler: $100
BOV: $200
Downpipe: $300
Exhaust piping: $150
Resonators: $150
Muffler: $60
Electronic Cutout: $150
Total: $1460
Price: $700
----------------------------------------
5spd transmission
Still bolted to engine
Will pull when bought
$200
----------------------------------------
6spd transmission
-was going into the car after rebuild
--change of plans
---unsure of condition, but should be good
--Came off JDM 99-00
$700
----------------------------------------
Torsen rear-end Type 2
-2002 SE
--4.3 gear
---Complete with axles and driveshaft
--off the drift-car, heavily used
$600
----------------------------------------
Torsen Type 2
-Came off same 99-00 as the 6-speed
-complete with axles and driveshaft
-was our backup set (can be used to swap for another miata)
$650
----------------------------------------
na8 motor
-off Tony's car
--Ran GREAT
---Never any problems
--Timing belt/water pump 8k
-140k, 50k boosted
--ACT Clutch and Flywheel
---6 puck sprung Heavy Duty
---Prolite 10.4lb
---^8k with 2 drift events
--NGK Power Cable set
-oil pan tapped for turbo
$600
----------------------------------------
MSPNP for 94-95 NA8
-off Tony's car
$550
550CC Red-top Injectors
$150
Both: $600
----------------------------------------
OEM Hood with pins
-Rustoleum paint
$75
----------------------------------------
OEM Fenders
-rolled and pulled
--to fit 16x8 et0 w/ 205-40-16
-Rustoleum paint
--includes fender markers
$150 for both
----------------------------------------
9998 by terry pham, on Flickr
_A225782 by terry pham, on Flickr
----------------------------------------
Pictures of all parts at:
http://www.flickr.com/photos/terrypham/
----------------------------------------
If you want more than one part, we can make a deal.
.
---------------------------------------
94-95 Turbo "Kit"
NA8 Intercooler setup:
2.5" piping on both cold side and hot side
Cold side has pipe for IAC
Cold side has bung for IAT
Comes with all silicons and t-bolt clamps
Designed for HKS manifold with t25/28
^no AC/PS
Blitz Blow Off Valve
-New Venturi Drive
Intercooler
^Core 21.5" x 9.5"
^^Overall 28" x 9.5"
Turbo 3" downpipe
-custom 2piece
--v-band setup
-no divorce
Turbo 3" exhaust setup
-fully custom
--two resonators
---quiet large muffler
--electronic exhaust cutout
Only parts needed to complete the turbo setup of how it was originally on tony's car are:
--t25/t28 turbo
--HKS manifold
Original cost of parts:
Aluminum Intercooler Pipes: $350
Intercooler: $100
BOV: $200
Downpipe: $300
Exhaust piping: $150
Resonators: $150
Muffler: $60
Electronic Cutout: $150
Total: $1460
Price: $700
----------------------------------------
5spd transmission
Still bolted to engine
Will pull when bought
$200
----------------------------------------
6spd transmission
-was going into the car after rebuild
--change of plans
---unsure of condition, but should be good
--Came off JDM 99-00
$700
----------------------------------------
Torsen rear-end Type 2
-2002 SE
--4.3 gear
---Complete with axles and driveshaft
--off the drift-car, heavily used
$600
----------------------------------------
Torsen Type 2
-Came off same 99-00 as the 6-speed
-complete with axles and driveshaft
-was our backup set (can be used to swap for another miata)
$650
----------------------------------------
na8 motor
-off Tony's car
--Ran GREAT
---Never any problems
--Timing belt/water pump 8k
-140k, 50k boosted
--ACT Clutch and Flywheel
---6 puck sprung Heavy Duty
---Prolite 10.4lb
---^8k with 2 drift events
--NGK Power Cable set
-oil pan tapped for turbo
$600
----------------------------------------
MSPNP for 94-95 NA8
-off Tony's car
$550
550CC Red-top Injectors
$150
Both: $600
----------------------------------------
OEM Hood with pins
-Rustoleum paint
$75
----------------------------------------
OEM Fenders
-rolled and pulled
--to fit 16x8 et0 w/ 205-40-16
-Rustoleum paint
--includes fender markers
$150 for both
----------------------------------------
9998 by terry pham, on Flickr
_A225782 by terry pham, on Flickr
----------------------------------------
Pictures of all parts at:
http://www.flickr.com/photos/terrypham/
----------------------------------------
If you want more than one part, we can make a deal.
.
#4
Tried PMing, can't due to posts, if you could email me at khyber6o3 at gmail.com that would be great, I'm interested in a few of your parts, and very local! Just drove out to work near Agoura from Northridge this morning! :P. Shoot me an email and I can give you my number to make things easier if that works. Thanks
-Max
-Max
Thread
Thread Starter
Forum
Replies
Last Post