V8roadsters control arms, OEM control arms/ES Bushings, Frog arms, ID1000, BE pump
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Sep 2010
Location: Austin
Posts: 217
Total Cats: -1
V8roadsters control arms, OEM control arms/ES Bushings, Frog arms, ID1000, BE pump
Shipping from Ann Arbor, MI - at your cost.
v8roadsters front lower control arms. $350
get moar camber!
boss frog frog arms $200 ($275 shipped new)
no hardware. just mocked up on a project car that never moved :(
NA6 OEM redline leather wrapped gauge hood (NA) - $100
all tabs intact!, leather alone was $135! leather not totally perfect where the hood meets the dash near the windshield, but difficult to notice.
Full set of NA control arms with energy bushings $500
Save yourself the PITA of removing and swapping bushings. Bushings installed and control arms painted. not used afterward. Upper ball joint boots are torn.
Freshly powdercoated NA rear subframe $125 (front sold)
never used after masking/sandblast/powdercoat. replace your rusty ones with these mint ones that were pulled off a 30k car. paid more for the powdercoating alone.
Boundary street pump new - $260
OEM 1.8 Drive shaft (needed for torsen swap) $50
-----------------------------------
OEM Headlight assemblies pair - motor, lights, covers $old
Miata tail lights pair (one has a small crack in inner plastic which does not affect function) $old
Miata side sills $old
ID1000's with pigtails $old
new , only tested.
v8roadsters front lower control arms. $350
get moar camber!
boss frog frog arms $200 ($275 shipped new)
no hardware. just mocked up on a project car that never moved :(
NA6 OEM redline leather wrapped gauge hood (NA) - $100
all tabs intact!, leather alone was $135! leather not totally perfect where the hood meets the dash near the windshield, but difficult to notice.
Full set of NA control arms with energy bushings $500
Save yourself the PITA of removing and swapping bushings. Bushings installed and control arms painted. not used afterward. Upper ball joint boots are torn.
Freshly powdercoated NA rear subframe $125 (front sold)
never used after masking/sandblast/powdercoat. replace your rusty ones with these mint ones that were pulled off a 30k car. paid more for the powdercoating alone.
Boundary street pump new - $260
OEM 1.8 Drive shaft (needed for torsen swap) $50
-----------------------------------
OEM Headlight assemblies pair - motor, lights, covers $old
Miata tail lights pair (one has a small crack in inner plastic which does not affect function) $old
Miata side sills $old
ID1000's with pigtails $old
new , only tested.
Last edited by xcoldricex; 06-28-2016 at 09:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Eunos91
MEGAsquirt
13
04-01-2016 02:50 PM
2manyhobyz
Insert BS here
5
03-21-2016 10:46 PM